Skip to main content

Tuning Info

Here is what I've learned about tuning SDR receivers, I am using RTLSDR Blog V4 receivers.

My Defaults

  • LNA → 165 (turn back towards 143 if crunchy
  • Mixer → 10
  • VGA → 82

Gain Values

LNA (Low-Noise Amplifier) – “Mic Preamp”

  • First active stage right after the antenna.

  • Best place to get real SNR because it boosts the signal before most noise gets added.

  • Too high → overload/intermod: noise floor jumps, strong stations smear all over, voice gets gritty.

  • Tuning rule: this is your main knob. Raise until signals pop and the floor rises ~5–10 dB, then back off one notch.

Mixer Gain – “Conversion Make-Up”

  • Small gain inside the frequency-converter that shifts RF down to IF.

  • Useful for a little extra oomph after you’ve set LNA.

  • Too high → subtle distortion/poorer decode without obvious overload symptoms.

  • Tuning rule: 0–2 clicks after LNA is usually enough; it’s a finesse knob.

VGA (IF Gain) – “Line Fader”

  • Variable gain after the mixer, before the ADC.

  • Mostly raises everything, including noise; doesn’t improve true SNR much.

  • Too high → looks louder, sounds hissier, decodes no better (often worse).

  • Tuning rule: keep low; only bump if the ADC is starving (very low dBFS).

Master Gain

  • A meta control that drives the three gains together using a heuristic.

  • When you set Master = Manual, you’re taking direct control of LNA/Mixer/VGA (good for digital voice).

AGC Switches

  • Tuner AGC: lets the R820T auto-ride the LNA.

  • RTL AGC: rides the IF/digital level in the RTL2832U.

  • For DMR/P25, leave both OFF while you dial things in; AGC “pumping” confuses decoders.

Sample Rate

  • How wide a chunk you’re grabbing. Higher rate = wider slice, a tad less forgiving, more USB/CPU load.

  • 1.92–2.048 MS/s is a sweet spot for RTLs.

How to use them together (practical)

  1. AGCs OFF.

  2. Set LNA first. Raise until the wanted signal is strong and the floor lifts a bit; if spurs/raspiness show up, back off.

  3. Add 1 click of Mixer if needed.

  4. Only then nudge VGA if the level meter is still very low.

  5. Watch dBFS: during voice bursts you want peaks roughly –25 to –15 dBFS. Constant –5..0 dBFS means clipping.

Symptoms Cheat-Sheet

  • Under-gain: Rest/voice barely visible; missed decodes. Fix: more LNA, maybe +1 Mixer.

  • Overload (too much LNA): Flat-topped peaks, birdies, gritty audio; BER worsens when you add gain. Fix: less LNA, or add attenuator/FM-notch.

  • Too much VGA: Looks louder, sounds hissier, no BER improvement. Fix: lower VGA.

  • AGC on: Waterfall/levels “breathe,” calls get chopped. Fix: AGCs off.

For Cap+ DMR specifically: prioritize LNA, keep VGA modest, use a click or two of Mixer, and aim for that –25..–15 dBFS window during voice. Once you get levels right, the hopping rest channel and LCN map do the rest.

Back to top